DNT One Tap Connect Instruction
Introduction
DNT One Tap Connect is a streamlined feature designed to simplify the connection between your digital scope and the DNT App. By eliminating the need to manually toggle Wi-Fi or switch between system settings and the app, it gets you ready to go with a single tap. While currently exclusive to the ZULUS 4K, this feature will be extended to other digital scopes in the near future via firmware updates.
Prerequisites
To use One Tap Connect, please ensure:
-
App Version: You have installed or updated to the DNT App v1.4.6 or later.
-
Bluetooth: Your phone’s Bluetooth is enabled.
-
Permissions: You have granted the DNT App permission to access Bluetooth in your mobile settings.
Steps to Connect
-
Power On the Scope: Power on your ZULUS 4K.
-
Open the App: Open the DNT App. The One Tap Connect window will appear automatically.
-
Confirm Connection: Tap [Connect] in the One Tap Connect window. A 4-digit confirmation code will appear on both the app and your scope.
-
Complete Setup: If the codes match, confirm the connection on your scope. The setup will complete automatically.
Important: If a pop-up appears asking for permission to join a WLAN network, tap Join.
Troubleshooting
-
One Tap Connect Window Does Not Appear: If the window doesn’t appear in the DNT App after power cycling your scope, the app may have stopped scanning. Tap the [Device] icon to restart scanning.
-
Connection Process is Stuck:
-
The scope may be connected to another device. Disconnect it from any other phone.
-
Make sure the DNT App is updated to the latest version.
-
Follow the instructions in the manual to connect manually.